Vaude MARK UL 3P Bedienungsanleitung Seite 18

ner tent foot and tension the pole. Starting in the
middle, attach the inner tent to the pole using the
toggle and ring.
5. Hang the tent skin on the front and rear pole con-
nectors using ridge hooks (D), then push into the re-
levant metal sockets at front and back (E).
6 Starting from the middle place the cords over the
ridge pole and hook over the loop below. Then, mo-
ving from above to below, proceed to do the same
with the other poles (F).
7. Anchor the porch and, if necessary, use guy ropes.
Please note: It is best to wrap the webbings of the
guy ropes around the poles (G).
8. Ensure that there is suffi cient ventilation. The porch
is ideal for individual adjustments.
TAKE DOWN – GENERAL INSTRUCTIONS:
• Remove everything from the tent's interior.
• Freestanding tents can be gently shaken out to
remove leaves, sand, and other debris.
• Turn the tent over with fl oor facing upward and
allow it to dry a bit longer.
• If it's not possible to dry the tent completely before
packing it, this should be done within 12 hours to
prevent the risk of mold and mildew growth.
• As in the tent set up, never pull the poles out of the
pole sleeves; rather push them through.
• When storing a tent in its stuff sack, make sure that
stakes and poles don't press against the tent fabric
and damage it.
• Before taking down your tent, close all zips and
roll up the guy lines. That way you won't have to
untangle them when it comes time to set the tent
up again, and pitching is that much easier.
DISMANTLING – "MODEL-SPECIFIC":
1. Pull out the tent pegs.
2. Unhook the ropes.
3. Remove fi rst the ridge pole and then the other poles.
4. Fold up the poles and roll them up with the tent, if
possible. Do not force the poles into the storage
bag if it is full as this may cause damage to the sto-
rage bag and tent.
ENGLISH
11