Ec Declaration Of Conformity; Machine Characteristics; Machine Parts And Controls; Intended Use - Makita SG150 Bedienungsanleitung

EN
3.2 eC Declaration of Conformity
Makita declares that the following
Machine(s):
Designation of Machine: Diamond Cutter
Model No. / Type: SG150, SG180
Conforms to the following
european D irectives:
2006 / 42 / EC
2014 / 30 / EC
2011 / 65 / EC
They are manufactured in accordance with
the following standard or standardized
documents:
The Technical file in accordance with
2006 / 42 / EC is available from:
Jan-Baptist Vinkstraat 2, 3070, Belgium
02.02.2015
Yasushi Fukaya
Director
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3.3 Machine characteristics
The machines are equipped with specially
developed electronics. It monitors the speed and
the green / red indicator lights (items 13 and 14,
see Figure ) help to achieve the most favourable
1
work progress and therefore tool-protecting working
conditions.
Visual display
Green: Speed for optimum cutting performance
Red: Speed too low – stopping
If this warning signal is ignored, i.e. the feed is not
reduced, the electronics switch off on overload.
After the diamond dry-cutting discs have stopped,
remove them from the chase. The machine can be
restarted immediately.
| 70 |
EN60745
Makita,
3.4 Machine parts and controls
(See Figure )
1
1 ON / OFF switch
2 Handle
3 Rear roller
4 Nozzle for dust extractor hose connection
5 Rotation direction arrow
6 Washer
7 Hexagonal screw (left-hand thread)
8 Diamond dry-cutting disc
9 Protective hood
10 Front roller
11 Front handle
12 Green LED
13 Red LED
 Working direction
3.5 Intended use
The diamond cutters listed in this instruction manual
are only approved for dry cutting in masonry (brick,
lime-sand blocks, undressed stone) and concrete.
They must not be used for wet cutting or for cuts in
metal, glass, wood, etc.
•
Observe the relevant regulations in your
country for the materials to be machined.
•
The diamond cutters are only approved for use
together with a dust extractor, which is suitable
for stone dust (e.g. MAKITA Special Dust
Extractor).
wARNING
Risk of injury due to cracking and breaking of
the diamond dry-cutting disc (bits of disc flying
around).
Î Diamond dry-cutting discs are designed for
straight cuts.
If used to cut curves the diamond dry-cutting
disc becomes deformed which causes internal
cracks and segments to break off.
•
Do not expose diamond dry-cutting discs to
lateral pressure.
•
Never use diamond dry-cutting discs for rough
grinding.