Velleman SPBS10 Bedienungsanleitung Seite 5

4. Features
• detection of obstacles when the vehicle is put into reverse
• beeps accelerate as the vehicle approaches the obstruction
• long detecting distance: up to 2m, high stability
• stable LCD with built-in buzzer, showing accurate distance to and direction of
• 4 black waterproof build-in sensors with a large beam angle for a minimized blind area
• installation height: 50-80cm
• consists of:
1 electronic control unit with 1m power cable
o
digital colour LCD with built-in buzzer & 6m cable
o
4 ultrasonic sensors with 2.5m cable each
o
user's manual, double-sided adhesive tape, 2 quick-on cable clips and hole saw
o
• spare parts: sensor (SPBS10/SENS)
5. Overview
Refer to the illustrations on page 2 of this manual.
Control unit
CU
Power connector
1
Display connector
2
Sensor connector (4x)
3
Reverse light circuit
R
A-B-C-D Sensors
Liquid Cristal Display
LCD
Sensor indication
A
Distance value
B
Sound on/off
C
STOP-Warning
D
Distance bar graph
E
support
F
6. Installation
Refer to the images on page 2 and 3 of this manual.
DO NOT apply power to the system before all connections are made. DO NOT apply power to the system before all connections are made.
Sensors
•
Determine the location of the sensors on the bumper carefully, as the proper functioning of the location of the sensors on the bumper carefully, as the proper functioning of
the system depends on it.
Note: beware that detection results might be affected when sensors are installed in steel beware that detection results might be affected when sensors are installed in steel
bumpers.
•
Refer to the pictures on page 3 for the best horizontal and vertical position. L=width of the
vehicle.
•
Also make sure no part of the bumper is blocking the view of the sensor. Also make sure no part of the bumper is blocking the view of the sensor.
•
Mark the location of the holes on the bumper and drill the holes with the included hole saw Mark the location of the holes on the bumper and drill the holes with the included hole saw
(Ø21.0mm).
•
Remove all burrs from the edge of the holes.
•
Insert the sensors and cables in the holes. All sensors are identical but their location will
determine the indications on the LCD. Therefore it is important to mount the sensors as
indicated in the illustration (A left, followed by B, C and D on the right).
•
Make sure the central axis of the sensor is perpendicular to the bumper surface. When Make sure the central axis of the sensor is perpendicular to the bumper surface
necessary, first slide an included washer over the sensor.
Note: The sensors can be repainted to match the colour of the bumper. However, the th The sensors can be repainted to match the colour of the bumper. However, the thickness of
the paint layer may not exceed 0.1mm!
31.07.2014
in buzzer, showing accurate distance to and direction of obstacles
in sensors with a large beam angle for a minimized blind area
microprocessor-controlled
Power is drawn from the cars' reverse light circuit. Power is drawn from the cars' reverse light circuit.
4 ultrasonic sensors
With buzzer. When the car reverses, this unit warns the driver With buzzer. When the car reverses, this unit warns
of obstacles via audio + display of direction of and distance to of obstacles via audio + display of direction of and distance to
the obstacle.
Indicates which sensor detects the obstacle. Indicates which sensor detects the obstacle.
Distance to closest obstacle.
Graphical indication of distance to closest obstacle. Graphical indication of distance to closest obstacle.
SPBS10
rizontal and vertical position. L=width of the
, C and D on the right).
5
on cable clips and hole saw
but their location will
to mount the sensors as
©Velleman nv