Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Turning On And Off; Important Information For Charging The Battery - Bosch BAT 430 Originalbetriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
en
16 | B�� 4�� | Operation
4.

Operation

4.1
�urning on and off
The power supply for the battery charger comes from
the lighting mains. The unit is factory set to 230 V,
50/60 Hz. The BAT 430 is turned on using the mains
switch (Fig. 1, Pos. 8).
i
BAT 430 automatically recognizes whether a 12 Volt
battery or a 24 Volt battery (series connection of
two 12 Volt batteries) is connected.
i
The back-up mode occurs if the terminal clips are
connected after switching on, and the buffer mode
occurs if the terminal clips are connected before
switching on (see Chapter 4.5).
|
1 689 979 996
2012-10-24
4.2
Important information for charging
the battery
If there is a pungent smell of gas, there is a
severe risk of explosion! Proceed as follows:
Avoid fire, naked flames and sparks.
Do not turn off the BAT 430.
Do not remove the charging clips.
Ventilate the room well immediately.
Move the rotary actuator to the extreme
left (minimum charging current).
After ventilating, turn the mains switch on
the BAT 430 to "0" (OFF).
Have the battery checked by a Bosch cus-
tomer service center.
Only charge batteries in well ventilated rooms.
Avoid fire, naked flames and sparks while charging
the battery.
Only connect intact batteries in parallel for charging.
Do not attempt to charge non-rechargeable batteries.
While charging totally discharged batteries, turn off
all consumers in the vehicle.
The mains connecting lead and the charging leads
must be in perfect condition.
Before connecting the BAT 430 to the mains, you
must set the mains switch to "0" (OFF).
On standard batteries, unscrew the inspection plugs
before charging.
When charging vehicle batteries in the installed condi-
tion, connect the black terminal clip (‒) to the body,
away from the battery and fuel pipe line.
Turn off the BAT 430 before disconnecting the charg-
ing clips.
Never disconnect the charging clips while charging is
in progress.
The battery may not be disconnected from the vehicle
electrical system while charging is in progress.
Never short circuit the charging clips.
Robert Bosch GmbH

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis