Novoferm B-1200 Montageanleitung Seite 42

Installation
Menu 1:
Program the start signal of the hand transmitter
1. Briefly press the programming button (PROG button) (D).
The display shows "1".
2. When the display flashes, press the hand transmitter button with which
you will later start the drive until the digital point (A1) on the display blinks
4 times.
3. As soon as the light goes out, you can set the next hand transmitter (see
Step 1).
Note: Up to 30 codes can be learned.
Menu 2:
Programming the 4-minute light
1. Briefly press the programming button (PROG button) (D) twice.
The display shows "2".
2. Press the button on the hand-held transmitter to control the light until the
digital point (A1) flashes 4 x.
3. As soon as the light goes out, you can set the next hand transmitter (see
Step 1).
Note: Programming the ventilation position and partial opening:
see menu 9.
Note: Up to 30 codes can be learned. (Example 15x start 15x light).
Delete all radio codes
1. Pull the mains plug.
2. Push the oval PROG-button (D) and keep it pushed.
3. Connect the mains plug to the socket and keep the PROG-button (D)
pushed until the digital dot flashes quickly.
42
B
D
C
A1
B
D
C
A1
B-1200