Program The Drive Head - Novoferm B-1200 Montageanleitung

10. Locking edge protection
P - Input for visual closing edge protection OSE or electrical contact strip
8k2
Pulse generator and external safety devices
In situations of increased requirements in terms of personal protection, we recommend, in addition to
the internal power limitation of the drive, the installation of a photoelectric sensor. Further information
on our range of accessories can be found in our sales literature. Consult your specialist dealer.
Warning label
Place the sticker clearly visible on the inner surface of the garage door.
Dismantling the operator
1. Pull out the mains plug and disconnect all existing terminals.
2. Disconnect garage door and operator. Fix garage door.
3. Proceed according to the Installation instruction poster, but in reverse sequence.

Program the drive head

This section describes the normal programming of the drive head during installation.
For further adjustments, or for special adjustments, refer to the section 'Special settings'.
Preparation
1. Make sure that the garage door is securely engaged in the carriage.
2. Make sure that the aerial is correctly positioned.
3. Make sure that you have all hand transmitters for this garage door at hand.
4. Open the cover of the drive head with a screwdriver.
5. Connect the mains plug to the mains socket. The point display lights up.
B-1200
Installation
P
WE WE
GN GN
BN BN
OSE
P
41