Troubleshooting; Type Of Trouble - ELCA MITO Betriebsanleitung

ENG man MITO-MINI 03

5. TROUBLESHOOTING

5.1 TYPE OF TROUBLE

TROUBLE
RADIO CONNECTION
FAILURE:
In continuous transmission
mode, pressing Start does
not activate radio connection.
(Check light off)
In discontinuous trasmission
mode
operating any control
will not cause Check light to
blink
or activate any command.
REPEATED RADIO
CONNECTION FAILURES.
In continuous transmission
mode, the transmitter shuts
down and radio connection
can only be restored using
the Start command.
In discontinuous trasmission
mode, the transmitter shuts
down before auto-shutdown
kicks in.
ONE OR MORE CONTROLS
FAIL TO ACTUATE THE
CORRESPONDING
MOVEMENT.
POSSIBLE CAUSE
bATTERY FLAT
TRANSMITTER -
RECEIVER NOT
MATCHED
SYSTEM OUTSIDE
OPERATING RANGE
SYSTEM IMPROPERLY
INSTALLED
RECEIVER OFF OR NOT
WORKING
PIN CODE ACTIVE
USEFUL FREQUENCIES
DISTURbED
For any causes other than
those listed above
FREQUENCIES
DISTURbED
RECEIVER
OFF
bATTERIES FLAT
EXTERNAL ANTENNA
(if fitted)
SYSTEM
IMPROPERLY
INSTALLED
For any causes other than
those listed above
DAMAGED FUSE
COMMAND
TRANSMISSION FAILED
WRONG WIRING
CONNECTION
- Page 17 -
Radio Remote Control System MITO-MINI
SUGGESTED REMEDY
Recharge the batteries (see Par. 5.4)
Access code storage procedure (see Paragraph 2.6).
For new systems, ensure serial numbers are correct.
Ensure that operating distance is within the allowed
range (see Chap. 6) and that system has been installed
correctly (see Paragraph 2.8)
Check system for proper installation (receiving unit
position, metal obstacles,...)
( see Paragraph 2.8)
Receiver shutdown will cause the transmitter to switch
off as well.
Power on the receiver (see Paragraph 5.3)
Unlock the PIN CODE (see Paragraph 3.4)
Ensure there are no other similar systems or sources of
noise such as radio bridges or transmitters. Check light
on steady with Start command maintained after 1 or 2
seconds. (see Paragraph 5.2)
(see Paragraph 5.2)
Change frequency (see Paragraph 3.2)
Receiver shutdown will cause the transmitter to switch
off as well.
Check battery charge level (see Par. 5.4)
Check for correct position and connection.
Check system for proper installation (receiving unit
position, metal obstacles,...).
(see Paragraph 2.9)
(see Paragraph 5.2)
Check the fuse inside the receiving unit
Ensure that the receiver light corresponding to the
command actuated from the transmitter turns on.
(see Paragraph 5.3)
Check wiring in receiving unit.