Information For Maintenance; Information For The Proper Installation Of The Radio Remote Control System - ELCA MITO Betriebsanleitung

ENG man MITO-MINI 03

2.7 INFORMATION FOR MAINTENANCE

Please remember that the receiving unit should be disconnected from power supply and the transmitting unit should be
powered off during maintenance procedures.
The Radio Remote Control System requires minimal maintenance, however, following these few simple tips will help
keep it in good working order.
TRANSMITTING UNIT
Periodically
- clean unit with a brush and wet cloth; avoid using alcohol, solvents or detergents
- ensure the battery charge contacts are clean
- check housing and rubber parts for damage
In addition, DO NOT:
- expose unit to jets of water or heavy rain
- leave unit exposed to sun radiation
- clean unit with jets of water or blow with compressed air
- immerse in water
- before storing the system away for long periods, fully charge the battery
RECEIVING UNIT
Periodically
- clean unit with a brush and wet cloth; avoid using alcohol, solvents or detergents;
- check housing and rubber parts for damage.
- check any connectors and/or cable glands for proper tightening.
In addition, DO NOT:
- clean unit with jets of water or blow with compressed air.
2.8 INFORMATION FOR THE PROPER INSTALLATION OF THE RADIO
REMOTE CONTROL SYSTEM
System must be installed and serviced by qualified and trained personnel.
Proper installation of the radio remote control is critical to ensuring proper operation and ease of maintenance.
Following are a few recommendations to be followed before and after installation:
- Perform a careful risk analysis to determine whether the machine is suitable for working in conjunction with a radio
remote control and identify any residual risks. The manufacturer of the machine and / or the installer of radio remote
control is responsible for this analysis. The ELCA Company can not be held responsible for the operation of its system
on applications where the risk analysis was not carried out properly.
- be aware that in case of interruption of the radio link for active stop, auto power off, low battery, power failure of the
receiver, radio range exceeded, interference, etc.. all the outputs of the receiver are turned off and it is no longer
possible to control the equipment until a further restart of the radio remote control. Carefully consider whether this can
be a danger.
- To obtain the maximum range, install the receiving unit between 2 and 10 metres above the ground and where there
are no obstacles between transmitter and receiver;
- install the receiving unit housing within easy reach to ensure safe access by repair or maintenance technicians;
- use multi-pin connectors to connect receiver to machine so as to facilitate replacement in the event of a failure;
- the place selected for receiving unit installation should be free from vibration: where this is not possible, use vibration
dampers;
- do not install the receiving unit inside metal casings that could affect its operation;
- ensure that there are no obstacles that could affect transmission between transmitting and receiving units: where
any obstacles cannot be eliminated, use the optional external antenna (special kit available) to ensure proper radio
communication;
- use cables with suitable cross-section area for wiring connections;
- be sure to connect power supply to the proper terminal;
- check for proper operation after installation.
- Page 10 -
Radio Remote Control System MITO-MINI