Kenwood KRC-694 Bedienungsanleitung Seite 33

The messages shown below display your systems
condition.
EJECT: No disc magazine has been loaded in the changer. The disc
magazine is not completely
Load the disc magazine properly.
No CD in the unit.
Insert the CD.
No Disc/ NO DISC:
No disc has been loaded in the disc
Load a disc into the disc magazine.
TOC Error/ TOC ER:
No disc has been loaded in the disc
Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD is
scratched a lot.
Clean the CD and load it correctly.
E-05: The CD is upside-down.E05
Load the CD correctly.
Blank Disc/ BLANK:
Nothing has been recorded on the
No Track/ NO TRACK:
No tracks are recorded on the MD, although it has a
E-15: Media was played that doesn't have data recorded that the
unit can play. E15
Use media that has data recorded that the unit can play.
No Panel/ NO PANEL:
The faceplate of the slave unit being connected to this unit
has been removed.E30
Replace it.
E-77: The unit is malfunctioning for some
Press the reset button on the unit. If the "E-77" code does
not disappear, consult your nearest service center.
loaded.E01
magazine.E02
magazine.E04
MD.E10
title.E11
reason.E77
— 33 —
Mecha Error/ MECHA ER:
Something is wrong with the disc magazine. Or the unit is
malfunctioning for some
Check the disc magazine. And then press the reset button
on the unit. If the "Mecha Error"/ "MECHA ER" code does
not disappear, consult your nearest service center.
Hold Error/ HOLD ER:
The protective circuit in the unit activates when the
temperature inside the automatic disc changer exceeds 60°C
(140°F), stopping all
Cool down the unit by opening the windows or turning on
the air conditioner. As the temperature falls below 60°C
(140°F), the disc will start playing again.
NO NAME: Attempted to display DNPS during the CD play having no disc
names preset.E51
Waiting/ WAITING:
Radio text data is being
LOAD: Discs are being exchanged in the Disc
Reading/ READING:
The unit is reading the data on the
IN (Blink): The tape player section is not operating
Reinsert the Tape. If the tape cannot be ejected or the
display continues to flash even when the tape has been
properly reinserted, please switch off the power and
consult your nearest service center.
reason.E99
operation.E0d
received.E56
changer.E57-1
disc.E57-2
properly.E60