Abicor Binzel SR/ABITIG GRIP Betriebsanleitung Seite 20

4 Putting into operation
Equip the torch neck according to the following figure:
1
5
1 Torch body
2 Gas nozzle
Fig. 1 Step 1-4
NOTICE
• Instead of the collet body, you may also use a gas diffuser. Due to its design, it will
produce a laminar gas flow.
4.2 Shortening the tungsten electrode
The electrode type is set by EN ISO 6848. The maximum electrode length depends on the torch
type.
NOTICE
• The welding performance is affected by the selection of the tungsten electrode and by
wear. A smooth, groove-free sharpened end of the tungsten electrode has a positive effect
on the welding result.
4.3 Connecting the cable assembly
1 Plug the hose assembly connection into the power source and secure it with a connection nut.
2 Properly mount the connections for water supply/return, shielding gas and control line plug.
EN - 8
Schritt 1 Schritt 2-3
4
3 Tungsten electrodes
4 Back cap
Schritt 4
3
5 Collet body
BAL.0047 • 2018-09-11
®
SR/ABITIG GRIP
2