Energy Saving; Function Programming - Divina SUP025MYDR Gebrauchsanweisung

ENGLISH
10 Turn the steam knob (16) anticlockwise to
empty out the contents of the water tank
MACHINE IS RINSING
11 When the machine rinse cycle is completed
the display will show:
RINSING FINISHED
CLOSE KNOB
12 Close the tap, reload the circuit and let the
machine heat up
If you use a product other than the
recommended one, you should
follow the manufacturer's directions on
the package.
11.1 Interrupting the descaling cycle
If the descaling cycle is interrupted
by switching the machine OFF, it will
automatically resume when the machine is
switched back ON.
The descaling cycle can be interrupted by turning
the steam knob (16) clockwise and then pressing
the button (27).
The display will show:
DESCAL. INTERRUPTED
EMPTY WATERTANK
Warning! After interrupting the cycle
you must empty the water tank of the
descaling solution and wash out the tank
with fresh drinking water; the machine
circuit must be cleansed by carrying out a
rinse cycle. The display will show:
RINSE MACHINE
PRESS KEY
Follow the directions for a normal rinse cycle
provided in section 8 of the previous chapter.

12 FUNCTION PROGRAMMING

The user can change some machine
operating parameters according to
personal needs.
12.1 MENU/OK command
In order to program functions you must access
the programming mode by pressing "MENU/
OK" (28) when the machine is in a standby status.
To select the desired function, press the "∧"
button to move up one line or the "∨" button to
move down on the display.
To exit the programming mode press "ESC"
12.2 Choosing individual functions
Select the desired function by pressing "∧" or
"∨". Press "MENU/OK" to enable the desired
function; you can browse the selectable settings
using the "∧" or "Ú" button; to store a setting
press "MENU/OK".
Note: by pressing "ESC" you can exit
the programming mode at any time
without saving the changes made; exiting
without saving is possible only before you
have pressed "MENU/OK".
12.3 Description of programmable
functions

ENERGY SAVING

If the appliance is used little, it may be switched to
the ENERGY SAVING mode. This function allows
electricity costs to be reduced. However, it is
recommended to switch the appliance off completely
using the on/off switch (7) if it is not to be used for a
prolonged period. It will take the machine just a few
minutes to heat up when you switch it back on.
• In the programming mode press "∧" or "∨"
to select the function:
ENERGY SAVING
and enable it by pressing "MENU/OK"; the
following message will appear:
ENERGY SAVING
in this mode the machine remains on but no
components are active.
• 34 •