Divina SUP025MYDR Gebrauchsanweisung Seite 33

clean it (Fig.24):
- lower the dispensing unit nozzles
- take the dispensing unit as shown in Fig. 24,
and remove it from its housing
- wash the whole unit with warm water.
10.1 The coffee dispenser
The coffee dispenser (17) must be
cleaned each time you fill the coffee
bean container or at least once a week.
• Switch off the appliance by pressing the ON/
OFF switch (7) to the "O" position and remove
the plug from the wall outlet.
• Open the service cover (15). Remove the drip
tray (12) and the coffee grounds drawer.
• Remove the coffee dispenser, holding it by its
handle and pressing the "PUSH" button
(Fig.22)
• Make sure that the two steel filters are free
from any coffee residues. The top filter can
be removed by unscrewing the plastic pin
anticlockwise using the key provided (Fig.23.).
• Wash the coffee dispenser only with hot water:
do not use detergents. Then thoroughly wash
and dry all its components.
• Refit the filter and carefully screw the plastic pin
back on using the key provided.
• Clean the compartment inside the appliance.
• Holding it by its handle, insert the coffee dispenser
into its housing until it snaps into place.
• Insert the coffee grounds drawer, the drip tray plate
and the drip tray.
• Close the cover (15).
11 DESCALING
Scale forms during normal use of the appliance;
a descaling treatment should be carried out
every 3-4 months, either when you notice a
reduced water flow or the following message is
displayed:
DESCALING
READY FOR USE
If you wish to carry this out at home,
you can use a commercially available
descaling product for coffee makers that is
non-toxic and/or not harmful.
Caution! Never use vinegar.
To descale the appliance proceed as follows:
1. Mix the descaling agent with water as
directed on the package and fill the tank
with the solution.
2. Switch on the machine by pressing the on/
off switch (7).
3. Press the button (27) for at least 5 seconds to
select the function; the following message will
appear on the display:
DESCALING
OPEN KNOB
4. Direct the steam pipe (14) over the drip tray.
5. Place a receptacle of adequate capacity
beneath the steam pipe and turn the hot
water knob (16) anticlockwise. The
machine will start an automatic descaling
cycle including pauses preset by the
manufacturer and automatically controlled
by the machine. The display will show:
MACHINE IS DESCALING
6. At the end of the cycle, the flow of
descaling solution will be stopped and the
display will show:
DESCALING FINISHED
CLOSE KNOB
7. Turn the hot water knob (16) clockwise to
shut off flow. The display will show:
RINSE MACHINE
FILL WATERTANK
8. Thoroughly rinse out the water tank and
fill it with fresh drinking water.
RINSE MACHINE
PRESS KEY
9. Place a receptacle of adequate capacity
beneath the steam pipe and press the
button (27).
RINSE MACHINE
OPEN KNOB
• 33 •
ENGLISH