Manual Filling Of The Water Tank; Emptying The Tank - Tecno-gaz ANDROMEDA VACUUM xp Benutzerhandbuch

TABLE OF QUALITY LEVEL IN ACCORDING TO DIRECTIVE DIN EN 285
CEN STANDARD DIN EN 285
Evaporation residue
Silicium oxide, SiO2
Iron
Cadmium
Lead
Rest of heavy metals except iron, cadmium, lead
Chloride (Cl')
Phosphate (P20s)
Conductivity (at 20° C)
PH value (degree of acidity)
Appearance
Hardness (E Ions of alkalin earth)
PAR. 10
In case the pump does not work, the loading tank can be filled by the operator in the following way:
1. Turn on the device.
2. Unscrew the cap.
3. Insert the supplied pipe for manual filling outside of which you can find a funnel.
4. Pour the distilled water in the funnel which is kept higher thank the loading cap;
5. Pour up to when the pilot light "LEVEL WATER TANK, max." is turned on.
6. Screw the cap checking its tightening.
PAR. 11
The device is fitted with a tank for collecting the waste waters used during the sterilisation cycle; this tank is
separated from the loading tank.
When the discharge tank is full, the max level pilot light "EXHAUST TANK", is turned on.
To discharge the tank, proceed as follows:
•
Connect the supplied pipe to the discharge tap.
•
Unscrew the discharge tap in counterclockwise direction.
•
Flow the waste waters.
•
Screw the discharge tap without forcing it and checking it is closed properly.
•
In case of sterilization failure, the used water in discharge tank, can have contamined residual. This
water must de disposal in the black water, use protettive latex glover to carry out the operation.
The device does not work in case the discharge tank is full. In case the operator tries to start a cycle even in
this state, the device locks visualising "ER3" on the "TIME/MESS". display.
PAR. 12

MANUAL FILLING OF THE WATER TANK

EMPTYING THE TANK

≤
≤
≤
≤
≤
≤
≤
≤
≤
Colourless clean without sediment
≤
23
10 mg/l
1 mg/l
0.2 mg/l
0.005 mg/l
0.05 mg/l
0.1 mg/l
2 mg/l
0.5 mg/l
µs/cm
15
5 to 7
0.02 mmol/l
DNVA208 Rev_5