Baninni TWIRL 360 BNCS021 Gebrauchsanleitung Seite 20

MANUAL
INSTALLATION OF THE
CHILD RESTRAINT SYSTEM:
Step 1: Install ISOFIX guide sleeves to ISOFIX lower anchorages.
Step 2: Press down the red button to adjust
longest Then put the ISOFIX attachments into guide sleeves ,and insert them into ISOFIX
anchorages. Make sure that you have heared a "click " and the ISOFIX latching indication shows
GREEN .Next,you can push the child seat towards the car seat backrest until it is firmly pressed
against the car seat backrest.If you want to release the ISOFIX attachments,just need to press
the ISOFIX red button. Then adjust the support leg to touch the ground completely (see 4.5)
INSTALLATION OF THE CHILD
1.Loosen the harness(see 4.3),and place
the child on the child seat.
2.Adjust the height of headrest(see 4.4).
3.Tighten the harness(see 4.3).
Installation status
IMPORTANT:
1.It will be stuck slightly when the seat
adjusted to this position,and there is no
locking effect in this position.
2.Do not place the child seat in this
position when the car ismoving.
3.You should turn it to the driving status
after installation of child .
ISOFIX attachment of both sides to the
Group 1(9-18kg)
IMPORTANT:
Not to use forward-facing before the child's weight exceeds 9kg.
Group 0+(0-13kg)
Driving status