Panasonic EY7460 Bedienungsanleitung Seite 4

Variable speed control trigger
Betriebsschalter
Gâchette de commande de vitesse
Grilletto di controllo velocità variable
Startschakelaar variabele snelheid
(M)
Disparador del control de velocided variable
Kontroludløser for variabel hastighed
Steglös varvtalsreglerare
Hovedbryter, trinnløs
Nopeudensäätökytkin
Battery charger
Ladegerät
Chargeur de batterie
Caricabatterie
Acculader
(O)
Cargador de batería
Batterioplader
Batteriladdare
Batterilader
Akkulaturi
Recommendations for use / Gebrauchsempfehlungen / Recommandations concernant l'utilisation /
Precauzioni d'uso / Aanbevelingen voor gebruik / Recomendaciones par el uso / Anbefalinger for brugen /
Rekommendationer för användning / Anbefalt bruk / Käyttösuositukset
Pack cover
Akkuabdeckung
Couvercle de la batterie autonome
Coperchio pacco
Accudeksel
Be sure to use the Pack cover
GB
• When the battery pack is not being used, store the battery in a way that foreign substances such as dust and
water etc. do not contaminate the terminals. Be sure to attach the battery pack cover to protect the battery
terminals.
• When charging the battery pack, confirm that the terminals on the battery charger are free of foreign
substances such as dust and water etc. Clean the terminals before charging the battery pack if any foreign
substances are found on the terminals.
The life of the battery pack terminals may be affected by foreign substances such as dust and water etc.
during operation.
CAUTION: To protect the motor or battery, be sure to note the following when carrying out this operation.
• If the motor or battery becomes hot, the protection function will be activated and the motor or battery will stop
operating.
The overheat warning lamp on the control panel illuminates or flashes when this feature is active.
For safe use
• The battery pack is designed to be installed by proceeding two steps for safety. Make sure the battery pack is
installed properly to the main body before use.
• If the battery pack is not inserted firmly when the switch is switched on, the overheat warning lamp and the
battery low warning lamp will flash to indicate that safe operation is not possible, and the bit will not rotate
normally. Insert the battery pack into the body of the tool until the red label disappears.
EY7460_EY7960_Book.indb 4
Cubierta de batería
Pakningsdæksel
Batteriskydd
Pakkedeksel
Akkukotelon kansi
label label etikett
Schild rojo merkki
rouge etikette
rossa dekal
Support handle
Zusatzgriff
Manche de support
Maniglia di sostegno
Steungreep
(N)
Mango de soporte
Hjælpehåndtag
Stödhandtag
Støttehåndtak
Tukikahva
Battery pack cover
Akkuabdeckung
Couvercle de la batterie autonome
Coperchio pacco batteria
Accudeksel
(P)
Cubierta de batería
Akkuafdækning
Batterilock
Batteripakkedeksel
Akun kansi
- 4 -
Terminals Terminales
Anschlüsse Terminaler
Bornes Poler
Terminali Ender
Aansluitpunten Liittimet
2012-10-18 14:56:04