Maintenance - Panasonic EY7460 Bedienungsanleitung

Information for Users on Collection and Disposal of Old
Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying
documents mean that used electrical and electronic products and batteries
should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used
batteries, please take them to applicable collection points, in accordance
with your national legislation and the Directives 2002/96/EC and 2006/66/
EC.
By disposing of these products and batteries correctly, you will help to save
valuable resources and prevent any potential negative effects on human
health and the environment which could otherwise arise from inappropriate
waste handling.
For more information about collection and recycling of old products and
batteries, please contact your local municipality, your waste disposal
service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in
accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or
supplier for further information.
[Information on Disposal in other Countries outside the
European Union]
These symbols are only valid in the European Union. If you wish to discard these
items, please contact your local authorities or dealer and ask for the correct method of
disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol. In this case it
complies with the requirement set by the Directive for the chemical involved.
V. MAINTENANCE
Use only a dry,soft cloth for wiping the unit.Do not use a damp cloth,thinner,benzine,or
●
other volatile solvents for cleaning.
In the event that the inside of the tool or battery pack is exposed to water,drain and allow
●
to dry as soon as possible.Carefully remove any dust or iron filings that collect inside the
tool. If you experience any problems operating the tool,consult with a repair shop.
VI. ACCESSORIES
Use only bits suitable for size of drill's chuck.
EY7460_EY7960_Book.indb 16
- 16 -
2012-10-18 14:56:09