Setting And Starting A Programme - Electrolux GA55GLIBR Benutzerinformation

12 www.electrolux.com
• If the rinse aid indicator is on, fill
3. Load the baskets.
4. Add the detergent. If you use multi-
tablets, activate the option Multitab.
5. Set and start the correct programme
for the type of load and the degree of
soil.
9.1 Using the detergent
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
9.2 Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
the rinse aid dispenser.
A B
30
20
C
CAUTION!
Only use detergent
specifically designed for
dishwashers.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press again and again until the
indicator of the programme you want
to select comes on.
• If you want to select the
MyFavourite programme, press
MyFavourite.
The programme duration flashes in the
display.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
• The programme duration stops
flashing and comes on with fixed
light.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with delay
start
1. Set a programme.
2. Press Delay again and again until the
display shows the delay time you want
to set (from 1 to 24 hours).
The delay time flashes in the display.
3. Close the appliance door to start the
countdown.
The delay time stops flashing and comes
on with fixed light.
• When the countdown is completed, the
programme starts.
• While the countdown is running only
the buttons Reset and Delay are active.
It is not possible to change the
programme or options.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you
close the door, the appliance continues
from the point of interruption.