Ferm OTM1003 Übersetzung Der Originalbetriebsanleitung Seite 5

DeSCrIPTIOn (fIg. A)
Your multitool has been designed for light sanding,
sawing and scraping applications.
1. On/off switch
2. Mounting point for accessories
3. Grip
ASSeMBLy
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the sanding pad and
the sanding paper (fig. B)
The sanding pad and the sanding paper must be
used for sanding applications.
Mounting
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (4) using the Allen key
(5).
● Mount the sanding pad (7) to the mounting
point (3).
● Tighten the Allen screw (4) using the Allen key
(5).
● Mount sanding paper (8) with the required
grain size onto the sanding pad (7). Make sure
that the perforation in the sanding paper (8)
corresponds with the perforation on the
sanding pad (7).
- Use coarse sanding paper (grain 50) for
sanding rough, uneven surfaces.
- Use medium sanding paper (grain 80) for
removing the remaining scratches from the
coarse sanding paper.
- Use fine sanding paper (grain 120) for
finishing surfaces.
removing
● Place the machine on a table with the mounting
point (3) facing upwards.
● Remove the sanding paper (8) from the
sanding pad (7).
● Loosen the Allen screw (4) using the Allen key
(5).
● Remove the sanding pad (7) from the mounting
point (3).
● Tighten the Allen screw (4) using the Allen key
(5).
Mounting and removing the saw blade (fig. B)
The saw blade must be used for sawing
applications.
Mounting
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (4) using the Allen key
(5).
● Remove the spacer (7).
● Mount the saw blade (9) to the mounting point
(3).
● Mount the spacer (7).
● Tighten the Allen screw (4) using the Allen key
(5).
removing
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (4) using the Allen key
(5).
● Remove the spacer (7).
● Remove the saw blade (9) from the mounting
point (3).
● Mount the spacer (7).
● Tighten the Allen screw (4) using the Allen key
(5).
Mounting and removing the scraping knife
(fig. B)
The scraping knife must be used for scraping
applications.
Mounting
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (4) using the Allen key
(5).
● Remove the spacer (7).
● Mount the scraping knife (10) to the mounting
point (3).
● Mount the spacer (7).
● Tighten the Allen screw (4) using the Allen key
(5).
removing
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (4) using the Allen key
(5).
● Remove the spacer (7).
● Remove the scraping knife (10) from the
mounting point (3).
● Mount the spacer (7).
● Tighten the Allen screw (4) using the Allen key
(5).
5