Preparing The Sweeper For Use; Adjusting The Driver's Seat; Filling The Fuel Tank; Opening The Fuel Tap - Kärcher KMR 1550 B Bedienungsanleitung

English
Preparing the
sweeper for use
-
28
Operating instructions for users
All directions given (left/right, front/rear) are as seen from the driver's seat.
n Check the oil level in the engine (see Chapter: "Maintenance").
n Check the level of coolant in the radiator (see Chapter: "Maintenance").
n Check the amount of fuel in the tank and fill up, if required (see below).
n Check the level of hydraulic fluid and top up, if required (see Chapter:
"Maintenance").
n Check the air pressure in the tyres (see Chapter: "Maintenance").
n Inspect the brush roller and remove any string, rope, etc., that may be
caught up in the brushes.
n Check the dust filter. If it is very dirty, operate the shaker to clean it off .
n Empty the waste container.

Adjusting the driver's seat

The driver's seat can be adjusted to fit people of different sizes.
n Pull the lever outwards.
n Adjust the seat position and release the lever.
n Move the seat back and forth to ensure that it has locked in position.

Filling the fuel tank

Explosion hazard while refuelling!
n Do not fill up with fuel
– in an enclosed space
– while the engine is running.
n Do not smoke while refuelling the vehicle.
n Fuel expands as it becomes warmer.
Do not fill the tank right up to the top. Leave a gap of at least 1 cm under
the bottom edge of the filler neck.
n Wipe up any fuel they may have been spilt and ensure that the cap is
replaced firmly on the tank.

Opening the fuel tap

n Open up the bonnet and make sure it locks in position.
n Open the fuel tap.
OPEN = Knob turned so that it is parallel to fuel pipe
n Close the bonnet.
Adjusting r.p.m. of side brush
n A clockwise turn reduces the r.p.m. of the side brush.
+
n A counterclockwise turn increases the r.p.m. of the side brush.
KMR 1550 B