Bluetooth Operation - auna 10026466 Handbuch

Before you can use the sound bar with your phone or other BTcapable device you will need to pair the device to
the sound bar.
NFC Compatible Smart phone
1 Touch the NFC-Mark on the unit with the smart phone.
2 Touch and hold until the smart phone responses. If promted for a confirmati-
on, enter „yes" or „confirm".
3 To remove the pairing, touch the NFC-Mark again.
Non-NFC compatible smart phone or other devices
1 Press the SOURCE button (2, 20) repeatedly until you see 'BT' appear on the display.
2 When selected, the 'BT' text on the display will flash while the unit tries to connect to previously paired de-
vices. If no devices are found the 'BT' text will still flash but to indicate it is ready for pairing a new device.
3 Enable the BT function on your smart phone and search for the Sound bar in the available list.
4 Select and enable pairing for the Sound bar. If prompted for a password enter '0000'.
5 If pairing is successful the sound bar will beep and the 'BT' text will stop flashing.
6 If the connected device goes out of range, the sound bar will attempt to connect for 2 minutes. When the de-
vice comes into range the sound bar will reconnect again automatically.
7 To remove the paired device using only the sound bar, press and hold the OPTION button (24) on the remote
control. The 'BT' text will begin flashing again.
BT status table
'BT' state
'BT' solid (no flash)
'BT' flash
Controlling a paired device
Once connected you can either use the controls on the audio device to begin playback, skip tracks etc.Or you can
use the control buttons on the sound bar & remote.
• The PLAY/PAUSE button (3 or 19) when pressed will begin playback of the selected track on the audio devic
Press again to pause playback.
• To skip to the next track press the SKIP button (4 or 29).
• To skip to the previous track press the SKIP button (4 or 22).
• Any further operations must be done from the audio device.
NOTE: the volume output is effected by the volume level on the audio source EG: Phone or laptop, so make sure
that is set to about 70-80% (not too loud to avoid distortion).
BT notes
• The operation range of BT is approximately 10 meters (30 Feet). Any obstacles in the path between devices may
reduce this range.
• Only one BT device can be paired at a time.
• Not all BT devices are compatible.
BT Operation
Reason
Connected
Auto re-connecting with last paired device.
Pairing mode
21