Microsd Card - HELIX PP50 DSP Handbuch

Installation of specific vehicle types setup files
The PP50 DSP offers the easy option of configuring the internal DSP amplifier to a specific vehicle type. All
you need is a MicroSD or MicroSDHC memory card. The card may contain other data such as photos from
a digital camera, however, note that it may contain only one setup file (af1 or af2 file) at a time.
1. Access the „plug & play" section of the Audiotec
Fischer (Germany/Europe) or Helixhifi (U.S.A.)
website. Select your model „PP50 DSP amplifier"
and finally your vehicle make and model. Down-
load and save the file to your computer.
2. Transfer the downloaded setting onto your
MicroSD card. You'll need less than 200 kB of
free memory space. Make sure there's only one
setup file on the card. This may be af1 or af2.
Note: All vehicle-specific setup files will have an
„.af2" ending. The file format „.af1" is only used
for operating software updates.
3. Finally, insert the card into the MicroSD slot
of the PP50 DSP. The status LED will blink red
for a few seconds. The setup file is then loaded
and saved in the PP50 DSP. The status LED
lights orange once the file has been fully loaded.
If you're updating the operating software or adju-
sting the amplifier using the „PC-Tool", the status
LED will show green.
20
Profile installation steps:
www.audiotec-fischer.com

MicroSD card

MicroSD-Slot PP50 DSP