Squelch; Key Tone; Roger Beep; Switching The Tx Power - Albrecht ATT 200 Anleitung

found, which opens the squelch and has the matching CTCSS tone, searching stops
and the signal is received. When the signal ends, the scanning continues after five
seconds.
To activate/deactivate, press the menu button 'M' three times. On the right side of
the screen blinks 'sc'. With the button '' or '' the Scan function is activated ('On')
or deactivated ('OF').
To exit the Scan, press the button 'M' once and switch this function off with '' or ''.
Note: When the Scan function is activated it is not possible to transmit or to change
menu settings.

3.8. Squelch

This function suppresses the receiver noise when no signal is received. Furthermore
the open squelch is the stop criterion for the scanning.
To adjust the squelch press the button 'M' four times. On the right side of the screen
blinks, 59 '. Select the sensitivity of the squelch from 0 to 6 with '' and '' . On step
1 even a weak signal will be heard. On step 6 all weaker signals are suppressed and
only strong signals are heard. At 0, the squelch is off.

3.9. Key Tone

When this function is activated the radio beeps, when buttons are pressed.
To switch, press the menu button 'M' five times. On the right side of the screen blinks
'Bp'. With the button '' or ' toggle the Key Tone on ('On') or off ('OF').

3.10. Roger Beep

Sends a tone sequence at the end of a transmission.
To switch, press the button 'M' six times. On the right side of the screen blinks 'rb '.
With the button '' or '' toggle the Roger Beep on ('On') or off (,OF')

3.11. Switching the TX Power

The TX power of this device has two selectable stages.
To select, press the button 'M' seven times. Right on the display blinks 'HL'. With the
button '' or '' toggle the TX power between high ('On') and low ('OF').
English 19