Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TECHNICAL DATA
Continuous power rating at 4 Ohms per channel .... 4 x 300 Watts RMS ................................... Impedance setting: 4 Ohms
Continuous power rating at 2 Ohms per channel .... 4 x 300 Watts RMS ................................... Impedance setting: 2 Ohms
Continuous power rating at 1 Ohm per channel ..... 4 x 300 Watts RMS ................................... Impedance setting: 1 Ohm
Continuous power rating, bridged at 4 Ohms .......... 2 x 600 Watts RMS ................................... Impedance setting: 2 Ohms
Continuous power rating, bridged at 2 Ohms .......... 2 x 600 Watts RMS ................................... Impedance setting: 1 Ohm
Frequency response..................................10 Hz - 80 kHz
Distortion (THD)................................................< 0.0005 %
TIM...................................................................< 0.0007 %
Signal-to-noise-ratio digital input............................> 116 dB
Signal-to-noise-ratio analog input.........................> 116 dB
Dimensions (H x B x T) in mm...................79 x 360 x 360
TROUBLE-SHOOTING
The BRAX MX4 PRO is in protection mode and the respective LED lights up yellow.
Cause:
The speaker wiring is faulty (short circuit between the wires or to the chassis of the vehicle).
Remedy:
Check the speaker wires or the speakers themselves for short-circuiting (p. 23 - 24).
Cause:
The impedance setting does not correspond to the impedance of the installed loudspeakers.
Remedy:
Check the impedance setting (p. 25).
The BRAX MX4 PRO is in protection mode and the protection LED is flashing yellow.
Cause:
The internal fuses are blown.
Remedy:
Exchange the internal fuses - only 25 Ampere mini blade fuses are allowed (p. 24).
The BRAX MX4 PRO is in protection mode and the temperature control LED lights up red.
Cause:
The amplifier is overheated. Depending on the outside temperature it will take some time until the amplifier
is cooled down and switches on again.
30
Damping factor........................................................> 1400
Input impedance RCA / Cinch..........................10 kOhms
Input sensitivity..............................................1.0 V - 8.0 V
Internal fuse..........................6 x 25 A LP-Mini-fuse (APS)
Weight net.................................................................12 kg
Werbung
Inhaltsverzeichnis
