Innotek FieldPro FP-RANGER -E Gebrauchsanleitung Seite 7

Step 2
1 1
The ON/OFF command only works when
the Transmitter and Receiver are in
close proximity; it will not work at a
distance. The ON/OFF command only
works when the Transmitter antenna is
installed.
Never turn the unit ON or OFF while
your dog is wearing the receiver collar.
Step 3
Step 4
Watch the included training DVD and read the information in the Training section
on page EN-17. Your dog may show good initial response to the training; be
sure to follow the training procedure for several weeks. The convenience that
your new remote training system offers is well worth the time invested.
FieldPro-E Owner's Manual
Turning the Receiver ON and OFF
2 2
3 3 c c m m
Fit the Collar on Your Dog
Put the collar around your dog's neck and adjust to
find the proper fit. Fasten the collar so the fit is snug,
yet loose enough to allow one finger to fit between the
strap and the dog's neck. Fit is important because a
loose collar may cause inconsistent performance.
Begin Training
SCOUT ™
3 3
Press
1 1 . . Put the threaded end of the Antenna
into the Transmitter and turn until
finger-tight.
2 2 . . Hold the Receiver one inch away
from the Transmitter — d d o o n n o o t t t t o o u u c c h h
t t h h e e R R e e c c e e i i v v e e r r ' ' s s c c o o n n t t a a c c t t s s — — y y o o u u
m m i i g g h h t t c c a a u u s s e e s s e e l l f f - - t t e e s s t t t t o o f f a a i i l l .
3 3 . . Press and hold the Tone button. The
Receiver's light will turn on and show
the level of battery charge (solid
green, amber, or red). Release the
Tone button.
4 4 . . To turn Receiver OFF, hold Receiver
and Transmitter one inch apart.
Press and hold the Tone button. The
Receiver will emit a shut-down tone
sequence, and the light will glow
solid red, then go out. Release the
Tone button.
N N O O T T E E for T T w w o o C C o o l l l l a a r r U U s s e e : : Set the Transmitter
to Dog 2 and repeat steps 2 and 3 using the
second collar.
Quick Start Guide
EN-7