Battery Indicator - Innotek FieldPro FP-RANGER -E Gebrauchsanleitung

R R A A N N G G E E R R O O N N L L Y Y : :
Ranger Transmitter Belt Clip
1. Press down and hold the Release on
the Belt Clip.
2. Slide the Belt Clip onto the lug on the
back of the Ranger Transmitter.
3. Let go of the Release and the Belt
clip will stay in place on the back of
the Transmitter. The Transmitter
swivels on the Belt Clip.
If you don't want to use the Belt Clip,
you may wish to remove the lug on the
back of the transmitter. Use a Phillips
screwdriver to remove the lug.
Press Down on the Release
Belt Clip Lug
RANGER
Back Side
EN-12

Battery Indicator

Battery is at 2/3 to Full capacity.
Transmitter is fully functional.
Battery is at 1/3 capacity.
Transmitter is still fully functional.
Battery is at 1/6 capacity.
Transmitter will operate the Receiver, but
recharge or replace Transmitter battery
as soon as possible.
Battery is almost dead.
Transmitter is unable to operate the
Receiver. Recharge to use again.
When the Battery Indicator shows the
low battery symbol (1/6 capacity), either
recharge your Ranger Transmitter soon,
or replace your Scout batteries soon.
When just the battery outline is
displayed, the Transmitter's battery is
unable to power transmissions to the
receiver. Transmitter must be recharged
(or Scout batteries replaced) to regain
operation.
Battery Cautions
Do not charge batteries every
night. To maximize battery life, use
the Transmitter until the low battery
symbol (1/6 capacity) displays, and use
the Receiver collar until the LED light
blinks red.
• Do not disassemble batteries
• Do not short circuit batteries
• Do not expose to high temperature:
60°C/140°F
• Do not incinerate batteries
• Keep batteries out of reach of children
Batteries must be recycled or disposed
of properly. Batteries should N N E E V V E E R R be
discarded in municipal waste.
FieldPro-E Owner's Manual