Automatic Time Setting; Receiving Measurements Automatically; Technical Data - Bresser Translucidus Schnellstartanleitung

9 Automatic time setting

After the power supply was established, the clock will auto-
matically search for the radio signal. This will take approxim-
ately 3 to 8 minutes to finish this process.
If the radio signal is received correctly, the date and time
will be set automatically and the radio control signal icon
turns on.
If the clock fails to receive the time signal, go ahead with the
following steps:
1.
2.
Read the detailed manual for more information about
manual time and alarm time settings (see download inform-
ation on page 2).
10 Receiving measurements
automatically
Once batteries are installed, the base station will display the
measurement readings. Readings from the remote sensor
will be displayed within 3 minutes after powering it on.
Read the detailed manual for more information about read-
ings (see download information on page 2).

11 Technical data

Base station
Batteries
Radio controlled signal
22 / 48
Press and hold the UP button for 2 seconds to re-initial-
ize RC signal receiving.
Is the device still not receiving the signal, the time must
be set manually.
2x AAA, 1.5V
DCF