Troubleshooting - AEG DVD 4550 HDMI Bedienungsanleitung

English
52

Troubleshooting

Before sending the machine to the Customer Services, use the following table to check whether you can rectify the
fault yourself.
Fault Possible cause
No power supply
No display
no power supply/ mains
switch switched off
No image displayed Video cable not correctly
on screen connected
no DVD/CD inserted
DVD/CD not compatible
DVD/CD incorrectly placed in
CD/DVD-tray
CD/DVD is dirty
CD/DVD is damaged
Incorrect settings
The child lock system is
activated
The wrong TV mode has been
selected.
No response when Power supply problem or
pressing button static charging of appliance
No sound Audio cable not connected
Amplifier switched off
Incorrect settings
The remote control wrong direction
does not work
too far away
Batteries empty
DVD cannot be DVD has not been finalized
played
Unit in USB Mode
Solution
WARNING:
Before troubleshooting, switch the player off.
Put the mains plug in correctly, if necessary, check the
socket is working with another appliance.
Switch the player on by the mains switch (Fig. 1/2).
WARNING:
Before troubleshooting, switch the player off.
Check the correct fit of the Video cable ï "Connecting
the Video cable". Make sure that the jacks are tightly
in the sockets.
Insert a CD/DVD.
Use only compatible media (see ï "Technical data").
Turn the CD/DVD around.
Clean the CD/DVD around.
Use a different CD/DVD.
Check the settings of your DVD-Player.
Deactivate the child lock. ï "Parental control"
Press the VIDEO (Fig. 3/26) button in stop mode in
order to change to TV mode.
Switch off the main switch and pull out the mains
plug. Insert the mains plug into the socket and switch
the player on again.
WARNING:
Before troubleshooting, switch the player off.
Video plug for transmission of the Video signal, you
must use and Audio cable in addition to the Video
cable ï "Connecting the Audio cable".
If you use an amplifier for Audio output: check
whether the amplifier is switched on.
Check the settings of your DVD-Player.

NOTE:
When connecting via HDMI, select the digital output
PCM in the audio menu.
The remote control is not pointed towards the DVD-
Player.
Make sure that the remote control is not further than
5 m away from the player.
Replace the batteries in the remote control
ï "Remote control battery installation".
Use a finalized DVD.
Press the DVD/USB button in Stop mode (Fig. 3/16) to
switch to CD/DVD mode.