Connecting The Video Cable - AEG DVD 4550 HDMI Bedienungsanleitung

Audio-/Video Cables

Connecting the Video cable

Fig. 2/10

NOTE:
The lifetime of the enclosed batteries may be shortened because of
storage.
1. Open and remove the battery compartment cover.
2. Insert two batteries of type AAA/R03 (1.5 V), ensure correct polarity
(+ and -). Start with the negative pole (-).
3. Attach and close the battery compartment cover.

NOTE:
The signals from the remote control are transmitted to the DVD-Player
by infrared light. You should therefore take care that the DVD-Player is
not exposed to the direct sunlight. This could make the transmission of
signals from the remote control to the DVD-Player impossible.
Effective range of the remote control
To use the remote, point it at the remote control sensor in the display
on the left hand side of the front of the device. The distance between
remote control and sensor should not exceed 5m. The angle of the re-
mote control to the remote control sensor to right, left, top and bottom
should not exceed 30°.

NOTE:
Only the use of audio/video cables of up to 1.5 m guarantees
interference-free operation.
The video cable transmits the video data from your DVD-Player to the TV
or the Video-Projector.
There are three different ways of connecting the DVD-Player with your
TV/Video-Projector. Select one of these possibilities to suit your replay
unit.

NOTE:
If you are not using a SCART or HDMI connection you must always
establish an additional audio connection for transmitting the audio
data (i.e. the sound).
SCART
SCART is used to transmit both Video and Audio data.
1. Plug the SCART jack firmly into the socket on the back of the player.
2. Plug the SCART jack into the corresponding socket on your playback
device.
3. Press the VIDEO button (Fig. 3/26) repeatedly to select the "RGB"
setting.

NOTE:
If you would like to select the "RGB" setting, please ensure that your
playback device supports this setting.
English
37