Troubleshooting - AEG DVD 4531 USB Bedienungsanleitung

English
58

Troubleshooting

Before sending the machine to the Customer Services, use the following table to check whether you can rectify the fault
yourself.
Fault
The power supply
light does not light
No image displayed
on screen
No response when
pressing button
No sound
The remote control
does not work
DVD cannot be
played
The USB connection
is not selected.
The memory card is
not selected.
05-DVD 4531 USB-CR_GB.indd 58 05-DVD 4531 USB-CR_GB.indd 58
Possible cause
No power supply
no power supply/ mains switch
switched off
Video cable not correctly
connected
no DVD/CD inserted
DVD/CD not compatible
DVD/CD incorrectly placed in
CD/DVD-tray
CD/DVD is dirty
CD/DVD is damaged
Incorrect settings
The child lock system is
activated
The wrong TV mode has been
selected (no P-SCAN-capable
playback device).
Power supply problem or static
charging of appliance
Audio cable not connected
Amplifi er switched off
Incorrect settings
wrong direction
too far away
Batteries empty
DVD has not been fi nalized
The USB storage medium and/
or memory card are inserted.
The CD/DVD and/or memory
card are inserted.
The CD/DVD and/or USB sto-
rage medium are inserted.
Solution
WARNING:
Before troubleshooting, switch the player off .
Put the mains plug in correctly, if necessary, check the
socket is working with another appliance.
Switch the player on by the mains switch (Fig. 1/1).
WARNING:
Before troubleshooting, switch the player off .
Check the correct fi t of the Video cable „Connecting
the Video cable". Make sure that the jacks are tightly in
the sockets.
Insert a CD/DVD.
Use only compatible media (see „Technical data").
Turn the CD/DVD around.
Clean the CD/DVD around ➯ „Handling CD/DVD".
Use a diff erent CD/DVD.
Check the settings of your DVD-Player.
Deactivate the child lock.
Press the VIDEO MODE button (Fig. 3/33) to change
the TV mode.
Switch off the main switch and pull out the mains plug.
Insert the mains plug into the socket and switch the
player on again.
WARNING:
Before troubleshooting, switch the player off .
Video plug for transmission of the Video signal, you
must use and Audio cable in addition to the Video cable
➯ „Connecting the Audio cable".
If you use an amplifi er for Audio output: check whether
the amplifi er is switched on.
Check the settings of your DVD-Player.
The remote control is not pointed towards the DVD-
Player.
Make sure that the remote control is not further than
7 m away from the player.
Replace the batteries in the remote control
➯ „Remote control battery installation".
Use a fi nalized DVD.
Remove the memory card and the USB storage medium.
Remove the CD/DVD from the CD compartment and the
memory card from the card slot.
Remove the CD/DVD from the CD compartment and the
USB storage medium.
21.02.2008 9:22:31 Uhr 21.02.2008 9:22:31 Uhr