Cancelling The Programme - Electrolux ESL7325RO Benutzerinformation

38 www.electrolux.com
approximately 3 seconds and then
shows the programme duration.
• To select the MyFavourite
programme, press
• The indicators of the options
related to the MyFavourite
programme are on.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
Starting a programme with
delay start
1. Set a programme.
2. Press
shows the desired delay time (from 1
to 24 hours).
The indicator
3. Close the appliance door to start the
countdown.
During the countdown, it is possible to
increase the delay time but not to change
the programme and options.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you
have to set the programme and options
again.
.
repeatedly until the display
is on.
Press and hold Reset until the appliance
is in programme selection mode.

Cancelling the programme

Press and hold Reset until the appliance
is in programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is completed the
display shows 0:00.
All buttons are inactive except for the
on/off button.
1. Press the on/off button or wait for the
Auto Off function to automatically
deactivate the appliance.
If you open the door before the
activation of Auto Off, the appliance
is automatically deactivated.
2. Close the water tap.
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.