Suction Head In The Fuel Tank - Dolmar HT-2556 D Bedienungsanleitung

Suction head in the fuel tank

– The felt filter (1) of the suction head is used to filter the fuel required by the
carburetor.
– A periodical visual inspection of the felt filter is to be conducted.
For that purpose, open the tank cap, use a wire hook and pull out the suction
head through the tank opening.
Filters found to have hardened, been polluted or clogged up are to be
replaced.
– Insufficient fuel supply can result in the admissible maximum speed being
exceeded. It is therefore important to replace the felt filter at least quarterly to
ensure satisfactory fuel supply to the carburetor.
Cleaning of muffler exhaust port
– Check of muffler exhaust port (2) regularly.
– If it is clogged by carbon deposits, carefully scratch the deposits out with a
suitable tool.
Do not allow carbon to fall into engine ports.
Any maintenance or adjustment work that is not included and described in this manual is to be performed by A uthorized Service A gent only.
Daily checkup and maintenance
To ensure a long service life and to avoid any damage to the equipment, the following servicing operations should be performed at regular
intervals.
– Before operation, check the machine for loose screws or missing parts. Pay particular attention to the tightness of the cutter blade screws.
– Before operation, always check for clogging of the cooling air passage and the cylinder fins. Clean them if necessary.
– Perform the following work daily after use:
• Clean the Hedge Trimmer externally and inspect for damage.
• Clean the air filter. When working under extremely dusty conditions, clean the filter several times a day.
• Check the blades for damage and make sure they are firmly mounted.
(1)
14
(2)