Inserting/Changing The Batteries - Bosch Zamo Originalbetriebsanleitung

32 | English
Adapter
Weight according to EPTA-Proced-
ure 01:2014
Dimensions
A) non-conductive pollution only, whereby occasional temporary
conductivity caused by condensation is expected
B) depending on surface characteristics and ambient conditions
Digital laser measure

Inserting/changing the batteries

It is recommended that you use alkaline manganese batteries
to operate the measuring tool.
– Insert the batteries (see figure on page 4). When inserting
the batteries, ensure that the polarity is correct according
to the illustration on the inside of the battery compartment.
The battery warning (a) is shown on the display when the bat-
tery voltage is weakening.
When the battery symbol
measurements can be made for approx. another 15 minutes.
When the battery symbol flashes, you have to replace the bat-
teries because measurements are no longer possible.
Always replace all the batteries at the same time. Only use bat-
teries from the same manufacturer and which have the same
capacity.
Do not use lithium-ion batteries. This may result in dam-
u
age to the measuring tool.
1 609 92A 454 | (14.06.2018)
38 x 48 x 22.3 mm
first appears on the display,
Bosch Power Tools
0.02 kg