Inserting/Changing The Batteries - Bosch UniversalDistance 50 Originalbetriebsanleitung

22 | English
Digital laser measure
Laser beam diameter (at 25 °C) approx.
– at 10 m distance
– at 20 m distance
Automatic switch-off after approx.
– Laser
– Measuring tool (without measurement)
Weight according to EPTA-Procedure 01:2014
Dimensions
Batteries
Battery life approx.
– Individual measurements
– Continuous measurement
A) For measurements from the rear edge of the measuring tool. The working range increases de-
pending on how well the laser light is reflected from the surface of the target (scattered, not re-
flective) and the brighter the laser point is to the ambient light intensity (interior spaces, twi-
light). For distances of less than 20 m, a retro-reflective target plate should not be used, as it
can lead to measurement errors.
B) For measurements from the rear edge of the measuring tool, 100% reflectivity of the target (e.g.
a white wall), weak backlighting and 25 °C operating temperature. In addition, a deviation influ-
ence of ±0.05 mm/m needs to be taken into account.
C) non-conductive soiling only, whereby occasional temporary conductivity caused by condensa-
tion is expected
D) At an operating temperature of 25 °C
The serial number (11) on the type plate is used to clearly identify your measuring tool.
Fitting

Inserting/changing the batteries

It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
Note that if you use 1.2 V batteries, you will not be able to perform as many measure-
ments as you would with 1.5 V batteries.
Push the locking mechanism (10) in the direction of the arrow to open the battery com-
partment cover (9) and remove the battery compartment cover. Insert the batteries.
1 609 92A 7LP | (02.05.2022)
UniversalDistance 50
9 mm
18 mm
20 s
5 min
0.08 kg
100 x 42 x 22 mm
2 x 1.5 V LR03 (AAA)
D)
10,000
D)
2.5 h
Bosch Power Tools