Bosch Zamo Originalbetriebsanleitung Seite 37

Digital laser measure with tape
adapter
Operation
– Switch on the measuring tool (see "Switching the laser
measure on/off", page 33).
Only use the tape adapter on clean and dust-free sur-
u
faces to avoid measurement inaccuracies.
Measuring length (see figures I1−I2)
After the measuring tool has been switched on, the tape exten-
sion is measured continuously. The current measured value
(g) is shown on the bottom line of the display. During continu-
ous measurement, the length of the tape can be adjusted, and
the current measured value (g) is updated on the bottom line
of the display.
The measuring process is indicated by a rolling arrow on the
display.
– Pull the tape (13) out of the adapter by the contact edge
(14) and place the tape against the object to be measured.
The visible length of tape (between the two red markings)
corresponds to the measurement length (in cm).
– Press the measuring button (1) to save the measured value.
The current measured value (g) is shown on the bottom line
of the display.
Press the measuring button (1) again to start a new meas-
urement. The current measured value (g) is shown on the
bottom line of the display, while the previous measured
value (e) is saved and shown on the top line of the display.
Note: When switching off the measuring tool, the current
measured value (g) is reset to "0", even if the tape is still
pulled out. To avoid measuring errors, always retract the tape
fully before taking a new measurement. Do not press the
Bosch Power Tools
English | 37
1 609 92A 454 | (14.06.2018)