Testing And Checking; Meaning Of The Leds - Schartec Jet 500 Anleitung

● F3 function settings:
Logic F3-1
Gate Status
Closed
Opened
Stop in the middle
Closing
Opening
Logic F3-2
Gate Status
Closed
Open
Stop during moving
Closing
Opening
Logic F3-3
Gate Status
Closed
Open
Stop during moving
Closing
Opening
●
The position of safety devices:
Safety Edge
Photocell

3.6 Testing And Checking

Make sure that all safety instructions and the warnings on page 3 and following have been carefully read and followed.
● Unlock the motor only with the supplied unlocking key.
● Make sure that the gate can be operated properly by hand with a maximum force of 390 N (40 kg).
● Now lock the motor again using the supplied unlocking key.
● Use a key switch, internal push-button, or remote control to check the opening, closing and stopping of the gate.
Make sure the gate is running in the intended direction.
● Check the function of each individual accessory (photocell, push-button, remote control, signal lamp, etc.) and
make sure the control unit confirms the function of each accessory.
3.7 Meaning of LEDs
LED Indication
LED1 Photocells
LED2 Photocells
PH2 Terminal
Photocells 2
Not allowed to open
No effect
Not allow to open
No effect
Closing
PH2 Terminal
Safety Edge
Not allowed to open
Re-load auto-closing time or Stop
Not allowed to open nor close
Open after two seconds
Close after two seconds
PH2 Terminal
Loop Detector
Open
Re-load auto-closing time or Stop
Open
Open
No effect
Photocell 1
Photocell 2
LED1 lights up when photocell 1 (Ph1) is activated.
LED1 lights up when photocell 2 (Ph2) is activated.
Re-load auto-closing time or Stop
Re-load auto-closing time or Stop
Re-load auto-closing time or Stop
Re-load auto-closing time or Stop
Loop Detector
Descriptions
32
PH1 Terminal
Photocells 1
Not allowed to open
Open
No effect
PH1 Terminal
Photocells 1
Not allowed to open
Open
No effect
PH1 Terminal
Photocells 1
Not allowed to open
Open
No effect