Adjusting The Menu Settings; Programmable Function Settings - Schartec Jet 500 Anleitung

3.4 Adjusting the Menu Settings

Step 1: Press and hold the "Set" button for 3 seconds, the display will show the function code.
Step 2: Choose the setting via the Up and Down buttons; after having chosen the desired submenu
item, press the Set button to enter the setting of this function. The second digit will be shown on the
right of the display, indicating the related function (please refer below chart for details). Use the Up
and the Down buttons to choose the setting function and press the Set key to save.

3.5 Programmable Function Settings

LED Display Definition
1
Gate Opening
Direction
2 Automatic Closing
Function of photocell,
safety edge, and loop
3
detector
Motor Speed
4
(in % of maximum
speed)
Soft-run distance
in % from full distance
5
Soft-run speed
in % of running speed
6
Function Value
1-1 Clockwise
1-2 Counterclockwise
2-0 No automatic closing
2-1 after 5 seconds
2-2 after 15 seconds
2-3 after 30 seconds
2-4 after 45 seconds
2-5 after 60 seconds
2-6 after 80 seconds
2-7 after 120 seconds
2-8 after 180 seconds
3-1
The settings can be found
3-2
under F3 functions
3-3
4-1 50%
4-2 70%
4-3 85%
4-4 100%
5-1 75%
5-2 80%
5-3 85%
5-4 90%
5-5 95%
6-1 80%
6-2 60%
6-3 40%
6-4 25%
30
Description
1. The function can adjust the direction of gate opening.
2. The factory setting is "1-2".
1. This function allows for automatic closing of the gate
after the desired time.
WARNING! This function is only allowed when
the photocell is connected and in operation.
2. The factory setting is "2-0".
1. Make this adjustment after setting H & J.
2. Factory setting is "3-1" = operation of photocell.
1.The function can adjust the running speed of motor.
2.The factory setting is "4-2".
.
1. The factory setting is "5-2"
1. The factory setting is "6-4"