Schartec Jet 500 Anleitung Seite 21

Performance
For the duration of the warranty, we shall resolve any defects of the product which are demonstrably
attributable to a material or manufacturing defect. At our discretion, we shall, free of charge, replace
the defective product for a non-defective, repair or refund a diminished value. Excluded are damages
caused by:
• Improper installation and connection
• Improper commissioning and operation
• External influences such as fire, water, abnormal weather conditions
• Mechanical damage due to accidents, dropping or shock
• Negligent or deliberate destruction
• Normal wear and tear or poor maintenance
• Repair by unqualified persons
• Use of non-original parts
• Removal or obscuring of the serial number
• Replaced parts become property of the manufacturer
IMPORTANT!
In the event of failure of the operator, a specialist must be directly commissioned for inspection and/or
repair of the operator / gate.
4. Checking the Gates / Gate system
The operator is not designed for the operation of heavy gates, i.e. gates which can not be opened or closed
with minimal difficulty by hand. It is therefore absolutely necessary to check the gate before installing
the operator and make sure that it can be easily moved by hand and that the gate system is safe.
Also, inspect the entire gate system (joints, hinges, bearings, and mounting parts) for wear and / or possible
damage. Check whether rust, corrosion or cracks are present. The gate system must not be used if repairs,
adjustments or maintenance work is required. An error in the gate system or an improperly adjusted gate
can also lead to serious injuries.
IMPORTANT!
Before installing the operator, make sure that any necessary repairs or adjustment / maintenance work are
carried out by a qualified person.
5. Important Instructions for Safe Installation
The installer of the operator must ensure that all national and European regulations for the operation of
electrical equipment are complied with.
6. Before the Installation
All mechanical locking devices of the door, which are not required for actuation with a swing gate opener,
must be disassembled before installation of the operator. These include, in particular, locking mechanisms
connected with the door.
7. When performing Installation
When carrying out the assembly and installation of the operator, the applicable safety regulations must be
observed.
IMPORTANT!
When drilling, the operator must be protected and covered so as to avoid later malfunction from drilling
dust or drilling chips.
8. After completion of Installation
Once the assembly has been completed, the installer must account for conformity to DIN EN 13241-1.
9. Warning notice
Ensure that permanently installed control devices (such as push buttons) are placed within sight of the
gate but away from moving parts and at a minimum height of 1.50 m. Keep out of reach of children.
Ensure that there are no persons or objects in the movement area of the door/gate. Ensure that children
do not play on or with the gate.
Make sure that the included warning signs are placed prominently on the door/gate.
21