Coding In And Deleting Remote Controls; System Learning And Resetting To Factory Settings - Schartec Jet 500 Anleitung

3.2 Coding in and deleting remote controls

(1) Coding in a remote control: Press "RF Learn" for 2 seconds, the LED display shows "CS". Now press the left remote control button (A) - the LED
display flashes three times and after 5 seconds goes out. The remote is now coded in.
(2) Deleting remote control memory: Press "RF Learn" for 5 ~ 6 seconds until the LED display turns on. Now wait until the display shows "CC" and
turns off again. All remote controls are now deleted from the memory.
LED2
LED1
1
2 2 Sec.
3.3 System learning or resetting to factory settings
! Attention: Make sure that the remote controls are taught in before the following steps
(1) System Learning
LED1
Step 1: Press "SET". Now press "SET" and "DOWN" for 3 seconds - the display shows "LE".
LED2
Step 2: Press the left button (A) on the remote control - The display shows "LP".
LED3
Step 3: The operator will now start the learning run. Wait until the automatic learning run is completed.
ON
OFF
1
A B
Press
ON
1~3 Sec
OFF
4
LED1
LED2
(2) Resetting to factory settings
LED3
Press "UP" and "DOWN" for 3 seconds - the display will show "CL". The operator is now back to the factory settings.
Push
3 seconds
1
Automatic power adjustment motor
The LED display shows during the learning run the current force setting during the movement.
ON
OFF
LED display
ON
2
LED1
LED2
LED3
Push
2
ON
OFF
5
2
"0.4": during the learning run, the operator determines the necessary forces for opening
and closing. Should the display indicate a constantly increasing value or a constantly high
value, this indicates that the gate mechanism is not intact or not properly maintained. If the
operator reverses or interrupts during the learning run, this is also an indication that the
gate mechanism is not running smoothly and without jerking. You should then have the
gate checked and repaired by a knowledgeable/qualified person.
A
B
LED display
blinks 3 times
Press
3 Sec
3
6
28
LED display OFF
3