Stake out function
One or two different distances (a and b) can be entered into the
device and then used to subtract from defined measured lengths.
Press
and the cursor flashes. Use + and – buttons to adjust the desired
value and then press
distance between the device and stake out point is displayed on the
display. At a distance of 0,1 m to the next stake-out point, an acoustic
signal sounds. When the stake-out point is reached the device will
issue signal sounds with greater frequency. Press
turn off Stake out function.
TECHNICAL SPECIFICATIONS
General characteristics
Measurement distance
Measuring accuracy
Battery type
Dimension
EN
Weight
Laser type
Laser class
Single measurement time
IP
Environmental requirements
Operating temperature
24
Owner's manual
button repeatedly until 0.000 appears on the display
button to start the measurement. The
0,5 m ~ 70 m
±1,5 mm
2x AAA (1,5 V)
126 x 54 x 28 mm
175 g (without batteries)
620-690 nm, <1mW
Class II
0,25 ~ 4 s
54
-10°C to +50°C
button to