Disabling The Control Of Zone Temperature; Operation In The Absence Of The Terminal - Bpt OH/Z.02 Bedienungsanleitung

home automation control terminals of
the home automation system (HOME
SAPIENS). The only possible operations
are the choice of AUTOMATIC or MANUAL
operating mode.
From AUTOMATIC operation (or ALL-
PURPOSE in NEHOS), it is possible to
change to MANUAL operation by press-
or and .
ing button
The display will show the previously
set temperature value, which can be
changed by up to ±2 °C from the value
set in the system by means of the button
or .
After about 5 seconds from the last oper-
ation, the room temperature appears.
From MANUAL operation (or HOLIDAYS
in NEHOS) it is possible to change to
AUTOMATIC operation by pressing the
button .
In AUTOMATIC operation it is not pos-
sible to change the temperature profile.
By means of the home automation sys-
tem control device (HOME SAPIENS) the
keypad of the module can be locked
against modification of its functions.
At any time, it is possible to check the
set temperature and the zone number
by pressing the button .
DISABLING THE CONTROL OF ZONE
TEMPERATURE
Press the button to deactivate the
temperature control of the zone where
the module is installed .
OPERATION IN THE ABSENCE OF
THE TERMINAL
The module is able to control the
temperature in a given zone, even in
the absence of a control terminal or if
the terminal is faulty.
It is possible to change the type of
operation (AUT, MAN, OFF).
In AUTOMATIC mode, the module runs
the set programme.
In MANUAL mode, the module main-
tains the set temperature.
To vary the type of operation (
Heating/ Cooling), keep the
pressed down for at least 4 seconds.
button
GB
33