Personalizing Temperature Level Values For The Heating Program; Personalizing Temperature Level Values For The Cooling Program; Personalizing The Daily Temperature Program - Bpt Th400Tx-Rx Gebrauchsanweisung

ting is made counts as a whole
day), figure 30.
1
Note. To return to AUTOMATIC
mode before the expiry of the pro-
grammed interval, press the
button, figure 31.
5 - PERSONALIZING
TEMPERATURE LEVEL
VALUES FOR THE
HEATING PROGRAM
5.1 - Open the front panel on the
thermostat.
5.2 - Make sure that the heating
program bar is enabled, or ena-
ble it by means of the
ton, figure 32.
5.3 - Press button T, figure 33.
The temperature band for T1
1 2 3 4 5 6 7
R
T
T3
T2
T1
0 4 8 12
1 2 3 4 5 6 7
R
T
T3
T2
T1
0 4 8 12
14
GB
appears on the display and the
value of the temperature assigned
to T1 (16 °C in the permanent
memory) is indicated instead of
the room temperature.
5.4 - Set the required temperatu-
re value for T1 by means of the
or
5.5 - Press button T to confirm
the temperature value indicated on
the display and move on to the
next temperature level, figure 35.
Note. The value which can be assi-
gned to each T level is restricted by
the values of the levels immedia-
tely before and after it, i.e., if level
T3 is set at 20 °C and level T1 is set
but-
at 16 °C, the value of T2 can only
be set between 16.1 °C and 19.9
°C. In order to achieve a value out-
side this range, e.g., higher than
19.9 °C, you must first change the
value of the adjacent level, e.g.,
ON increase the value of T3.
5.6 - Repeat steps 5.4 and 5.5 to
vary the values of the other tempe-
rature levels.
16 20
The reappearance of the whole
daily program graph confirms the
Fig. 32
ON
R
T
16 20
Fig. 33
button, figure 34.
1 2 3 4 5 6 7 ON
T3
T2
T1
0 4 8 12 16 20
Fig. 34
end of the temperature level pro-
gramming sequence.
After 10 s without any further ope-
rations being performed, the ther-
mostat abandons the procedure,
retaining the most recent settings.
5.7 - Close the front panel on the
thermostat.
6 - PERSONALIZING
TEMPERATURE LEVEL
VALUES FOR THE
COOLING PROGRAM
Open the front panel on the ther-
mostat. After selecting the
(cooling) operating mode, set the
temperature levels required as
explained from step 5.3 above
onwards. Close the front panel on
the thermostat.
7 - PERSONALIZING
THE DAILY TEMPERATURE
PROGRAM
7.1 - Open the front panel on the
thermostat.
7.2 - Using the 1÷7 button, bring
1 2 3 4 5 6 7 ON
R
T
T3
T2
T1
0 4 8 12 16 20
Fig. 35