Getting Started; Unpacking Prestige; Inserting The Battery In The Remote Control - Sonoro PRESTIGE SO-330 Bedienungsanleitung

3.

Getting started

3.1

Unpacking PRESTIGE

1. Take PRESTIGE out of the packaging and check whether PRESTIGE or the
individual parts exhibit damages. If this is the case, do not use PRESTIGE. Should
you detect any damage, contact your dealer or sonoro audio GmbH customer
support immediately.
2. Check to make sure that the delivery is complete (see chapter "Scope of delivery").
3. Place PRESTIGE at a suitable location.
4. Remove the protective film from the display.
5. Remove the protective card from the subwoofer driver.
3.2

Inserting the battery in the remote control

1. Open the battery compartment cover on the back of the remote control by turning
it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3. Replace and close the battery compartment cover by turning the cover clockwise
using a small coin.
Do not block the infra-red sensor on the PRESTIGE and the infra-red transmitter on
the remote control during use.
© sonoro audio GmbH 2018
GB
71