Getting Started; Unpacking Maestro; Inserting The Battery In The Remote Control - Sonoro MAESTRO SO-1000 Bedienungsanleitung

3.

GETTING STARTED

3.1 UNPACKING MAESTRO

1. Take MAESTRO out of the packaging and check whether MAESTRO or the
individual parts exhibit damages. If this is the case, do not use MAESTRO.
Should you detect any damage, contact your dealer or sonoro audio GmbH
customer support immediately.
2. Check to make sure that the delivery is complete (see chapter "Scope of delivery").
3. Place MAESTRO at a suitable location. If you want to put your MAESTRO on a
natural wood surface, please make sure that it is suitable. On oiled and waxed
surfaces, stains may occur.
4. Remove the protective film from the display.

3.2 INSERTING THE BATTERY IN THE REMOTE CONTROL

1. Open the battery compartment cover on the back of the remote control by turning
it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3. Replace and close the battery compartment cover by turning the cover clockwise
using a small coin.
Do not block the infra-red sensor on the MAESTRO and the infra-
red transmitter on the remote control during use.
88 © sonoro audio GmbH 2019