auna IR-110 Anschluss- Und Anwendungshinweise Seite 16

• Insert the adaptor plug into the DC socket located at the rear side of the radio. Plug the adaptor into
a wall socket outlet.
Caution: Use only the adaptor supplied with the radio. Connecting a power supply with a different
rating will cause permanent damage to the radio and may be hazardous.
Press STANDBY to switch on.
• After initially turning the device on, you will be prompted to select the menu language.
Use the arrow buttons to do so, and confirm by pressing SEL. All menues are to be operated in
this particular way.
• Next, you will be asked whether the option "Check Network when Power on" shall be activated.
Select YES to automatically connect the radio to your WiFi for future use.
• In the next step, configure your network, or skip this step by selecting NO. In the latter case, continue
with setting the time (also, using the arrow buttons and SEL).
To configure your network now, select YES, or YES WPS if your network is WPS protected. You can also
access all network configurations to a later time via the main menu.
After a short search, a list with WiFi networks within range will be displayed, as you may know it from
your smartphone or tablet. From this list, select your WiFi, then enter your WiFi password to connect
(arrow buttons and SEL).
If your WiFi router is equipped with a WPS button, you can select the WPS PBC option to connect. In
this case you only have to press the WPS button on your router within 2 minutes to connect.
Your auna radio is now ready to use.
16
Initial Use / Setup
Configure your radio