Acer WLAN-G-RU2 Benutzerhandbuch Seite 29

4.5.1.2. Type the Old Password in the box. The default password is
1234.
4.5.1.3. Type a New Password in the box.
Note :
Password must be less than 64 characters.
4.5.1.4. Type the new password in the Confirm Password box.
4.5.2. To Restore the Factory Default Configuration:
4.5.2.1. On the Tools page, click Restore to Default next to Restore
Factory Defaults.
The Warning dialog box appears, see FIGURE 4-15:
FIGURE 4-15: Warning Dialog Box
4.5.2.2. Click OK.
Important:
Restoring the default factory settings will reset all of the router
configurations in every page, so we recommend that you backup the
configuration data from the Gateway to your PC first using DOS
commands. For details, see To Backup or Restore the Configuration
Data Using DOS Commands.
In addition, you can also restore the factory defaults using DOS
commands. For detailed instructions, see To Backup or Restore the
Configuration Data Using DOS Commands.
4.5.3. To Backup or Restore the Configuration Data Using
DOS Commands:
For the backup of the configuration data from the Gateway to your
PC, Gateway acts as a TFTP server.
To backup the configuration data, under the DOS window, use the
following command:
tftp –i gateway_Ip_address GET filename
24