Acer WLAN-G-RU2 Benutzerhandbuch Seite 21

4.4.1.5. Enter the following advanced radio parameters:
Parameter
Beacon
Interval
RTS Threshold
Fragmentation
Threshold
DTIM Interval
Preamble Type
Distribution
System
Note :
You can see the default values of the above advanced wireless settings
on the right of the page. If you don't know how to change the settings,
please leave as they are in Figure 4-8:
associated work in one of channels from 1 to 14.
Description
Type the time interval in milliseconds
between beacons broadcast by AP (Access
Point) in the Beacon Interval box, such as 100.
Type a number in the RTS Threshold box.
Also called Request-to-Send Threshold. This
field specifies the minimum size of data
frames above which RTS protocol is used,
ranging from 256 to 2432. RTS helps prevent
data collision from hidden nodes.
Type a number in the Fragmentation
Threshold box.
For efficiency in high-traffic situations, large
files are split into fragments. This field
specifies the default packet size, an even
number ranging from 256 to 2346.
Type a number in the DTIM Interval box.
Also called Delivery Traffic Indication Map.
This field specifies the number of beacon
intervals between successive DTIMs, ranging
from 1 to 255.
Select either Short Preamble (72 bits) or Long
Preamble (144 bits).
If you want to use Wireless Distribution
System on your Router, click Enable next to
Distribution System, then type the distributed
client PCs' physical addresses, as described
in Step 6.
Otherwise, click Disable.
16