Setting Up A New Local Wlan Network - Sentiotec PRONET Webserver Montage- Und Gebrauchsanweisung

Instructions for installation and use

5.1. Setting up a new local WLAN network

You can use any standard, commercially available WLAN router with an Ethernet
connection to set up a new local WLAN network. The pronet web server is con-
nected directly to the WLAN router, and is therefore registered in the network as
a separate device with a specific IP address.
As a default setting, the web server has been allocated the IP address:
which is used to access it.
● Enter the IP address in the address bar of your Internet browser.
► If the web server is accessible, a log-in window appears, in which you
must enter your user name and password.
The following standard settings are used:
User:
Password:
► If you are unable to connect to the web server, proceed with the following
item Setting up a WLAN router. Observe the operating instructions for
your router when doing so.
Setting up a WLAN router
1. Use your PC, tablet, smartphone, etc. to connect to the router using WLAN.
► If you are unable to connect to it using WLAN, use a network cable to
connect the router to your PC and follow the instructions provided by the
router manufacturer in order to access the device configuration.
2. Enter the IP address of your router in the address bar of your browser
(see the instructions for the router).
► The configuration page for your router opens.
3. Change the IP address of the router to e.g. 192.168.0.100 and, if necessary,
the subnet mask to 255.255.255.0.
► Save the settings and try to connect to the web server again.
192.168.0.110
sauna
sentiotec
p. 12/26