Before First Use; Daily Use; Loading The Laundry - AEG LP 1480 F Benutzerinformation

8.7 U./Min. - T/Min.
With this option you can decrease the
default spin speed.
The display shows the indicator of the set
speed.
Additional spin options:
No Spin
• Set this option to remove all spin
phases.
• Set it for very delicate fabrics.
• To compensate for the absence of
spinning, the rinse phase uses more
water for some washing programmes.
• The display shows the indicator
.
Rinse Hold

9. BEFORE FIRST USE

1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
4. Put a small quantity of detergent in
the compartment for washing phase.

10. DAILY USE

10.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press button Ein/Aus - Marche/Arrêt
to activate the appliance.
A short tune sounds.

10.2 Loading the laundry

1. Open the appliance door.
2. Put the laundry in the drum, one item
at a time.
3. Shake the items before you put them
in the appliance.
Make sure you do not put too much
laundry in the drum.
4. Close the door firmly.
• Set this option to reduce creasing.
• The washing programme ends with
water in the drum. The drum turns
regularly to reduce creasing.
• The door stays locked. You must drain
the water to unlock the door.
• The display shows the indicator
To drain the water refer to
"Draining water out after
end of cycle".
8.8 Temp.
Set this option to change the default
temperature.
Indicator = cold water.
The display shows the set temperature.
5. Set and start a programme for cotton
at the highest temperature without
laundry.
This removes all possible dirt from the
drum and the tub.
CAUTION!
Make sure that no laundry
becomes trapped between
the seal and the door. There
is a risk of water leakage or
damage to the laundry.
ENGLISH 15
.