Inhaltsverzeichnis
Werbung
Maintenance and Cleaning
1. Regularly clean the suction pump.
2. Pull the plug form the power plug.
3. Press the push button (A) completely down until
it locks audible.
4. Hold the housing on the top and press out the
suction pump (C) with you thump.
5. Remove the suction pump and clean the
interior. You can easily remove the tin with a
small and firm brush.
6. To insert the suction pump back into the
housing, make sure the push button is pressed
completely down. Place the suction pump on the
housing and lightly press the suction pump
down.
7. Slide the suction pump into the housing.
Hints for Desoldering
When desoldering, do not heat up the soldering
point for too long, 1 to 3 seconds are enough.
When heating up the soldering point for too long,
annular rings may melt and damage electronic
components.
Operation
7
1
2
3
Werbung
Inhaltsverzeichnis
