Cleaning And Maintenance - Wetekom 68 80 44 Bedienungsanleitung

Cleaning and Maintenance

 For the best result and a long service life always keep the soldering
tip tinned.
 Regularly clean dirty soldering tips with a wet soldering sponge or
the
they are hot.
 If the soldering tip has became passive and will not take to the
solder easily, take it out of the soldering iron. Thoroughly clean it
with 600 – 800 grid emery cloth. After that the tip must be tinned
again. Roll some solder with a flux core around the tip and heat up
the tip until the solder has molten around the tip. Using additional
colophony may be helpful.
 If the tips are finally worn out, replace them to preserve the full
performance of the soldering station.
 Please pull the power plug before cleaning and allow it to cool down
fully!
 Avoid exerting excessive pressure on the LC display (1).
 Use only a stiff brush and a moist cloth to clean the unit and allow it
to dry out before the next use.
 Do not use aggressive chemicals or abrasives to clean the unit.
Operation
soldering tip cleaner, article number 50 01 40 while
15